Barco FLM R22+ Guia do Utilizador descarregar pdf (Página 197)

17. Removal of the projector covers

17. REMOVAL OF THE PROJECTOR COVERS

About this chapter

Most maintenance and servicing procedures demand removing one or more of the projector covers to gain access to the parts to

maintain or to service. To avoid redundancy, all procedures about cover removing or installing are grouped together in this chapter.

The maintenance and servicing procedures also refer to this chapter if required. The procedures in this chapter describe, with

detailed step by step actions and illustrations, how to remove or install the projector covers. Note that some covers may only be

removed by qualiﬁed service personnel, see remarks above each procedure.

WARNING: Always switch off the projector and unplug the power cord at the projector side before removing

one of the covers.

Overview

• Removal of the front cover

• Removal of the side cover

• Removal of the lamp cover

• Removal of the input cover

• Installation of the front cover

• Installation of the side cover

• Installation of the lamp cover

• Installation of the input cover

17.1 Removal of the front cover

Necessary tools

7mmﬂat screw driver.

How to remove the front cover of the projector ?

1. Remove the lens. See chapter "Lens removal", page 26.

2. Remove the rubber dust ring from the lens holder. See image 17-1.

3. Release the captive screw at the middle bottom of the front cover, using a ﬂat screw driver.

Image 17-1

4. Remove the front cover from the projector doing the following:

a) standing in front of the projector, pull the right side of the front cover toward you until the latches release (left side is hinged)

b) then slide the front cover to the right to release it from the hinging points.

R59770179 FLM R22+ 15/03/2010

193

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 242 243

Sem comentários

Barco FLM R22+ Guia do Utilizador Página 197