Barco Coronis 3MP Guia do Utilizador descarregar pdf (Página 26)

5. Advanced operation

5.9 Hibernate

About hibernate

Enabling hibernation will not only switch off the backlight but will also force the display to disable other

functionalities so that power consumption is further reduced to a minimum. This happens after a speciﬁc

period of time which can be manually adjusted.

Hibernate can only be enabled on your display when the DPMS mode is enabled ﬁrst.

Therefore, please refer to "DPMS mode", page 21 to do this.

To enable/disable hibernation on your display:

1. Bring up the OSD main menu.

2. Navigate to the Conﬁguration > Power Management menu.

3. Enter the Hibernate submenu.

4. Select Enabled/Disabled as desired and conﬁrm.

To specify th e hibernate timeout:

1. Bring up the OSD main menu.

2. Navigate to the Conﬁguration > Power Management menu.

3. Enter the Hibernate Timeout submenu.

4. Set the timeout value as desired and conﬁrm.

5.10 Luminance target

About the luminance target

The luminance target of your Coronis 3MP LED Display is adjustable over a predeﬁned range. When you

change the luminance target, the display will adjust its backlight to reach the target.

To set the luminance target:

1. Bring up the OSD main menu.

2. Navigate to the Conﬁguration > Calibration menu.

3. Enter the Luminance Target submenu.

4. Set a luminance target value as desired and conﬁrm.

5.11 Viewing modes

About viewing modes

The Coronis 3MP LED Display can be used in two viewing modes:

K5902060 CORONIS 3MP LED DISPLAY 10/04/2013

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

Sem comentários

Barco Coronis 3MP Guia do Utilizador Página 26