Barco PDS Manual de Instruções descarregar pdf (Página 95)

PDS • User’s Guide 79

4. Operation

Using Inputs

rëáåÖ=^ìíç=^ÅèìáêÉ

Please note the following important points regarding the Auto Acquire mode:

• If Auto Acquire is ON and a valid input is selected that does not have a saved

Input Config file associated with it, the system attempts to acquire the source and

save an Input Config file. This process may take a few moments.

• If an input is selected that does have a saved Input Config file associated with it,

the (blinking) source will transition to program after TAKE is pressed.

• When the system performs an Auto Acquire for Inputs 5 through 8, the PDS first

checks for a DVI signal. If not found, the system looks for a valid analog signal.

• If Auto Acquire is OFF and a valid input is selected (either with or without a

saved Input Config file), the system compares the library file to the input’s

incoming timing.

~ If the timings match, the system transitions to the input after TAKE is

pressed.

~ If the timings do not match, the “Invalid Signal” message appears, and

the system transitions to black after TAKE is pressed.

rëáåÖ=ea`mWith PDS, the HDCP mode is essentially automatic. Provided that you

connect an HDCP compliant monitor, you can select and switch between unprotected

sources and “protected” HDCP sources (e.g., a Blu-Ray player) without restriction.

• Inputs 1 through 4 (analog) are unprotected sources.

• Inputs 5 through 8 (analog) are unprotected sources.

• Inputs 5 through 8 (digital) are protected when an HDCP source is connected.

Please note the following important points regarding HDCP operations:

• When the input signal is an HDCP source on DVI inputs 5 through 8 and a valid

HDCP monitor is connected, the following actions occur:

~ The PDS’s analog output is disabled.

~ You cannot store a logo from a “protected” source. However,

“unprotected” logos that are already stored in the system can be

switched to Program.

~ You cannot use the FRZ button.

For the latest HDCP features, refer to Chapter 7, “PDS-902 3G Enhancements

” on

page 107.

Note

The Input Config file will only be saved if the "Auto Input

Save" mode is ON in the User Preference Menu.

Note

As a prerequisite, ensure that you have read the “A Word

About HDCP” section in Chapter 1 on page 1 prior to reading

this section.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 201 202

Comentários a estes Manuais

Sem comentários

Barco PDS Manual de Instruções Página 95

Comentários a estes Manuais

Manuais e produtos relacionados com Comutadores de rede Barco PDS