Barco PDS Manual de Instruções descarregar pdf (Página 66)

50 PDS • User’s Guide

4. Operation

Setup Menu

oÉÅ~ää=`çåÑáÖ

From the Input Menu, select Recall Config to restore a configuration file that was

previously associated with the current input. Using the Recall Config Menu shown in the

following illustration, you can change from the current configuration file for the input to any

saved configuration file:

Figure 4-21. Recall Config Menu (sample)

A number in brackets indicates the only file that is available for recall. If no files are

available, a message will be displayed to indicate that there are no saved files.

After you select a file number and choose Recall File, press SEL to initiate the recall or

ESC to continue using the current configuration.

When you press SEL, if the input timing matches the timing in the recalled input

configuration file, the input uses the recalled configuration file immediately. The File

Association Menu is also updated to reflect your change.

If the input and configuration file timings do not match and Auto Acquire is ON, an “auto

acquire” will be performed. For more information about this function, refer to the “Using

Auto Acquire” section on page 79.

aÉäÉíÉ=`çåÑáÖ

From the Input Menu, select Delete Config to delete any saved configuration file. A

deleted configuration file cannot be recalled by any input.

After you delete a configuration file, what happens the next time you select an input that

uses the file depends on whether Auto Acquire is ON (in the User Preference Menu).

When Auto Acquire is ON and an input does not have a saved configuration file, the PDS

does a full sync (timing) acquisition on the selected input signal.

When Auto Acquire is OFF, the system will use the configuration file defined in the File

Association Menu, to the greatest extent possible. If the input does not have a saved

configuration file, the PDS displays the “Invalid Signal” message and the video output is

black.

For more information about Auto Acquire, refer to the “Using Auto Acquire

” section on

page 79 and the “Auto Acquire

” section on page 79.

 Use the following procedure to delete a configuration file:

1. From the Input Menu, select Delete Config. The menu shown in the following

illustration is displayed:

Figure 4-22. Delete Config Menu (sample)

RECALL CONFIG

> File Number 41

Recall File

DELETE CONFIG

> File Number 1

Delete File

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 201 202

Comentários a estes Manuais

Sem comentários

Barco PDS Manual de Instruções Página 66

Comentários a estes Manuais

Manuais e produtos relacionados com Comutadores de rede Barco PDS