Barco ClickShare Manual de Instalação descarregar pdf (Página 41)

6. ClickShare Web Interface

To change

1. Log in t o the ClickShare web interface.

2. Click the Se tup tab (1) and then the Display tab (2).

The content of the Display tab is shown. The ﬁrst pane s hows the Display Settings.

Image 6-9

Display settings

3. To show the meeting room and network info on the meeting room display, check t he check box behind the c orresponding item.

4. Resolution setup. Click on the drop-down list and select the desired resolution.

Note: The maximum output resolution supported by ClickShare is 1920 x 1080. This is also the default.

5. Click Apply to conﬁrm your change s.

6.8 Display output settings

About display output settings

A screen saver can b e ac tivated after a certain time. The delay time to activate the s creen saver can be set v ia the slider bar.

When the slider is set completely to the right, the screen saver will never be activated. S lide the slider to the left until the desired

delay time is reached. T his delay time can never be l

arger than the Display Timeout. A warning will be displayed when the delay

time is larger than the display timeout after clicking on Apply.

Display Timeout : If there is no input signal detected during the display timeout period, both outputs are set to blank.

How to change

1. Log in t o the ClickShare web interface.

2. Click the Se tup tab (1) and then the Display tab (2).

R5900014 CLICKSHARE 30/04/2014

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 71 72

Sem comentários

Barco ClickShare Manual de Instalação Página 41