Barco Technospot Manual do Utilizador descarregar pdf (Página 20)

CHAPTER 2

Setup and Configuration

10 Technospot

User Manual

Use the following steps to mount a Technospot fixture on a standard truss:

1. Fix the clamp on the bracket by tightening the M12 screw on the bracket to the hole in the

center of the bracket.

2. Insert the quick-lock fasteners of the first Omega holder into the respective holes on the

bottom of the fixture. Tighten the quick-lock fasteners fully clockwise.

3. Install the second Omega holder.

CAUTION!

Only experienced lighting personnel should attempt to hang a lighting

fixture to an appropriate theatrical truss.

WARNING!

In all cases, a safety cable should also be fixed between the safety cable

mounting point located at the bottom of the fixture base housing and the

truss. Failure to use a safety cable could result in injury or death. High End

Systems supplies the proper safety cables and may be contacted for

replacements if necessary. For more information go to:

www.highend.com/trusshang.

1. Omega-holders

2. Clamp

3. Safety cable

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 69 70

Sem comentários

Barco Technospot Manual do Utilizador Página 20